Welcome to the Jeep Forum.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

<<<<<< Register to remove these ads >>>>>>

Go Back   Jeep Forum > Jeep Forum - Jeep Models > General Discussion
Become a Supporting Member         Become a Preferred Vendor

General Discussion

GC rearend change

This is a discussion on GC rearend change within the General Discussion forums, part of the Jeep Forum - Jeep Models category!
I am having replacing the rearend (whole thing hub to hub) in my 97 GC. I have located one out ...

LinkBack Thread Tools Display Modes
Old 06-20-2018, 04:56 PM   #1 (permalink)
Junior Member
Join Date: Jun 2018
Name: Michael
Posts: 1
Default GC rearend change
I am having replacing the rearend (whole thing hub to hub) in my 97 GC. I have located one out of a 96 GC for the right price but the guy says the drive shaft enters on the upper half of center and mine enters on the lower half of center. Am I going to have any problems with this ?
mbarnes is offline   Reply With Quote
Old 10-17-2018, 07:40 AM   #2 (permalink)
Full Access Member
Join Date: Aug 2018
Location: Pittsburgh, PA
Name: John
Age: 48
Posts: 86
Did you ever get an answer to your question? I was just curious as to what you found out about the rear end and how the shaft enters.
ZEN357 is offline   Reply With Quote


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On